Description
Description:
This is a Waveshare 2-inch LCD Display Module. A general LCD Module with an IPS screen, 2-inch diagonal, 240×320 resolution, embedded controller, communicating via SPI interface. 2-inch LCDÂ Module supports Raspberry Pi, Arduino, STM32, etc.
Specifications:
| Operating Voltage | 3.3V / 5V |
| Resolution | 240 × 320 pixels |
| Communication Interface | 4-wire SPI |
| Display Size | 30.60 × 40.80mm |
| Display Panel | IPS |
| Pixel Size | 0.0975 × 0.0975mm |
| Driver | ST7789VW |
| Module Size | 58.0 × 35.0mm |
Features:
- 240×320 resolution, 262K colors, clear and colorful displaying effect
- SPI interface minimizes required IO pins
- Comes with online development resources (examples for Raspberry Pi/VisionFive2/Arduino/STM32)
Pin Description:
| VCC | Power (3.3V / 5V input) |
|---|---|
| GND | Ground |
| DIN | SPI data input |
| CLK | SPI clock input |
| CS | Chip selection, low active |
| DC | Data/Command selection (high for data, low for command) |
| RST | Reset, low active |
| BL | Backlight |
Useful Link:
Waveshare 2 Inch LCD Display Module
Package Included:
- 1 x 2inch LCD Module
- 1 x PH2.0 20cm 8Pin
3.5mm Terminal Connector 3.5mm Pitch 2 pin 2 way Straight Pin PCB Screw Terminal Block Connector 
Raspberry Pi 4 Model-B 8GB SDRAM Raspberry PI 4B SBC IOT Board - Broadcom 1.5GHZ A72 Processor 
DPDT Switch Push to ON OFF Horizontal Switch 
Radiolink R8FM RC Receiver R8FM 8 Channels 2.4GHz Micro RC Receiver SBUS/PPM for Mini FPV Racing Drone, Quad, Aircraft T8S/T8FB Transmitter 
UNO R3 Development Board Arduino UNO Compatible R3 Microcontroller Development Board compatible with Arduino IDE 
SMD UNO R3 Arduino Compatible ATmega328 Board UNO R3 SMD Development Board CH340G SMD UNO Board 
10x15mm Cable Drag Chain 10 x 15mm 1m Cable Drag Chain Wire Carrier 
3296W 10k Trimpot Trimmer Potentiometer 103 10k Ohm Miniature Adjustable Trimpot Variable Resistor For PCB Mounting
Reviews
There are no reviews yet.