Description
Description:
This is a Waveshare 2-inch LCD Display Module. A general LCD Module with an IPS screen, 2-inch diagonal, 240×320 resolution, embedded controller, communicating via SPI interface. 2-inch LCDÂ Module supports Raspberry Pi, Arduino, STM32, etc.
Specifications:
| Operating Voltage | 3.3V / 5V |
| Resolution | 240 × 320 pixels |
| Communication Interface | 4-wire SPI |
| Display Size | 30.60 × 40.80mm |
| Display Panel | IPS |
| Pixel Size | 0.0975 × 0.0975mm |
| Driver | ST7789VW |
| Module Size | 58.0 × 35.0mm |
Features:
- 240×320 resolution, 262K colors, clear and colorful displaying effect
- SPI interface minimizes required IO pins
- Comes with online development resources (examples for Raspberry Pi/VisionFive2/Arduino/STM32)
Pin Description:
| VCC | Power (3.3V / 5V input) |
|---|---|
| GND | Ground |
| DIN | SPI data input |
| CLK | SPI clock input |
| CS | Chip selection, low active |
| DC | Data/Command selection (high for data, low for command) |
| RST | Reset, low active |
| BL | Backlight |
Useful Link:
Waveshare 2 Inch LCD Display Module
Package Included:
- 1 x 2inch LCD Module
- 1 x PH2.0 20cm 8Pin
12V 100 RPM Geared Motor Johnson DC Gearbox Motor High-Torque 100 RPM Geared Motor High-Performance 100 RPM DC Geared Motor 
220 Ohm Resistor, 220 Ohm Resistance 1/4W Power Rating 5% 
1200mAh 18650 Battery 3.7V 18650 Rechargeable Battery Li-ion Battery 
FlySky FS-CT6B 2.4ghz Digital Proportional 6 Channel Transmitter 
FlySky FS-i6 Transmitter Receiver FS-i6 2.4G 6CH PPM RC Transmitter With FS-iA6B Receiver with LCD screen for RC Drones 
Radiolink R6DSM RC Receiver R6DSM 2.4Ghz 10 Channels Micro RC Receiver SBUS/PPM for Mini FPV Racing Drone, Quadcopters Aircraft, AT9S AT9S Pro/AT10/AT10II Transmitter 
Hobbywing 5V/6V 3A Switch-Mode UBEC, Max 5A Lowest RF 
Raspberry Pi Zero WH Pi Zero WH Wireless Raspberry Pi 0 WH Built-In WiFi And Bluetooth Pre-soldered GPIO Headers 
0.4mm 3D Printer Nozzle 0.4mm MK8 M6 Nozzle 3D Printer Nozzles 
GT2 Timing Belt 10M GT2 Width 6mm Black Open Timing Belt For 3D Printer
Reviews
There are no reviews yet.