Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
32 Channel Robot Servo Control Board Servo Motor Controller PS2 Wireless Control USB/UART Connection Mode Versatile Servo Controller For Robotics And Automation Projects 
Single 18650 Battery Holder With Wire Leads and Spring Contacts 3.7v Battery Case Reliable 18650 Battery Holder For Your Projects 
10K Ohm Resistor, 10K Ohm Resistance 1/4W Power Rating 5% 
5MP HD Raspberry Pi Noir Camera Versatile Wide-Angle Fisheye Lens OV5647 Video 1080p With Focal Lens For Night Vision Projects, Security Monitoring 
BeagleBone Black Rev C Development Board Cortex-A8 Board Open-Source Hardware Compact Development Platform 
LilyPad Tri-Color LED RGB Module For arduino LilyPad LED Module Tri-color 
M12 High Resolution Lens, 12MP, 113° FOV, 2.7mm Focal length, Compatible with Raspberry Pi High Quality Camera M12 
1045 Propeller 10*4.5 inch Propeller 10x4.5 CW CCW Propeller Pair for Quadcopter 
5V 2A Wireless Charging Coil Module Wireless 5V 2A Power Transmitter/Receiver High-Power Wireless Charging Coil 
Nitecore Ci4 USB-C 4-Slot Battery Charger Li-ion Battery Charger With Intelligent Charging and Real-Time Monitoring For Efficient Power Management 
1K Ohm Resistor, 1K Ohm Resistance 1/4W Power Rating 5% 
JX Servo PDI-HV2107MG Servo Motor 21g High Torque Digital Standard Servo For RC Model 
Pro Micro Atmega32U4 Development Board 5V 16M Mini Development Board Pro Micro 5V 16M Mini Leonardo Microcontroller Development 
N20 3V Vibration Motor Compact DC Vibration Motor With Counter Weight Vibration Motor For Electronics High-Performance Vibration Motor Powerful Small Vibration Motor For Wearable Devices
Reviews
There are no reviews yet.