Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
RDS3115MG 15KG Standard Servo Kit RDS3115 360° Continuous Rotation Servo Kit For Robotics and Automation 
Raspberry Pi Fisheye Camera 5MP Wide Angle Camera 160° 15-Pin Pi Camera MIPI Interface Raspberry Pi Camera for Raspberry Pi 2/3/4/B/B+/Zero/W/2W 
CH340 Nano Board CH340/ATmega328P without USB Cable, Compatible with Arduino Nano V3.0 (Soldered) 
EMAX MT2213 935KV Brushless DC Motor - Red Cap (CCW Motor Rotation) With 1045 Propeller Combo (Original) 
NEMA17 Stepper Motor Cable Pure Copper 1000 mm Cable with Connector for NEMA17 Stepper Motor 
5S 40A BMS Board 5S 40A 18650 Li-ion Lithium Battery Charger Protection Board 
Natural White PLA PRO+ 
Arduino MEGA 2560 R3 CH340 Board ATmega2560 Development Board Arduino Compatible 
Radiolink R6FG RC Receiver R6FG 6 Channels 2.4GHz RC Receiver with Gyro, Surface Long Range Control RX for Vehicle Drifting/Crawler/Truck/Boat Works with Radio Controller RC4GS V3/RC6GS V3/RC4GS V2/RC6GS V2/T8FB/T8S 
17HS3401 NEMA Stepper Motor NEMA 17 Stepper Motor NEMA 17 Stepper Motor With 4-Pin Cable Quiet And Smooth Stepper Motor For 3D Printing And CNC Machining 
Fluo Popsicle Orange PLA PRO+ 
Raspberry Pi 5 Single Board Computer with 2.4GHz quad-core, 64-bit Arm Cortex-A76, and LPDDR4X-4267 SDRAM 8GB 
Readytosky 80A 2-6S Brushless ESC 2-6S Brushless Electronic Speed Controller (ESC) High Power 80A ESC For FPV Racing Drones and Quadcopters 
10.1" LCD Display IPS LCD Screen 1280×800 With Driver Board Kit Raspberry Pi Compatible With and All Version of Pi 
1K Ohm Resistor, 1K Ohm Resistance 1/4W Power Rating 5% 
5MP Raspberry Pi Camera 1080p Adjustable Focus Camera OV5647 Focus Camera Raspberry Pi Camera Module Raspberry Pi 3/2 Model B/B+ 
Official Raspberry Pi 3 Case Pi 3 Official Case Protective Enclosure ABS Case for Raspberry Pi 3B/ Pi 3B+ Black 
18*30cm Universal PCB Prototype Board 18*30 cm Universal PCB Prototype Board Single-Sided 2.54mm Hole Good For DIY Soldering Electronic Projects Green Thickness
Reviews
There are no reviews yet.