Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
15 RPM N20 Gear Motor 3V Micro Metal Gear Motor Mini Gear Motor N20 Micro Gear Motor N20 3V 15RPM Gear Motor 
Raspberry Pi 5 Single Board Computer with 2.4GHz quad-core, 64-bit Arm Cortex-A76, and LPDDR4X-4267 SDRAM 4GB 
Raspberry Pi Camera Module 3 with 75°/ 120° 12mp Sony IMX708 Image Sensor 
Smart Robot Car 2WD Chassis Kit with Ultrasonic Module R3 Board 
Readytosky 80A 2-6S Brushless ESC 2-6S Brushless Electronic Speed Controller (ESC) High Power 80A ESC For FPV Racing Drones and Quadcopters 
Waveshare 4.3inch Capacitive Touch LCD 800x480 Pixels Resolution IPS Panel 216 Colors Via 24-Bit RGB Interface For Pi 
7408 IC 74LS08 Quadruple 2-Input Positive And Gate IC DIP-14 
Nextion NX8048T050 5.0" HMI Touch Display 5-inch Basic Series Display Touchscreen Display for Arduino Raspberry Pi 
HQProp T63MMX8 Propellers Light Grey Polycarbonate Propeller Precision Crafted Polycarbonate Blades For Reliable and Powerful Flight - 2CW & 2CCW 
100pcs 10Value 16V Tantalum Capacitor Kit 1uF-100uF Capacitors Assortment Kit With Plastic Box For DIY Electronics Projects 
Radiolink R8FM RC Receiver R8FM 8 Channels 2.4GHz Micro RC Receiver SBUS/PPM for Mini FPV Racing Drone, Quad, Aircraft T8S/T8FB Transmitter 
220 Ohm Resistor, 220 Ohm Resistance 1/4W Power Rating 5% 
N20 Micro Gear Motor N20 12V 200 RPM Micro Metal Gear Motor With Encoder 
1200mAh 18650 Battery 3.7V 18650 Rechargeable Battery Li-ion Battery 
Universal GPS Mount Universal GPS Folding Antenna Base Set, GPS Fixed Mount Base Antenna Signal Foldable Seat For Quadcopter Racing Drone
Reviews
There are no reviews yet.