Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
iMAX B6AC Charger iMAX B6 LCD Screen Digital RC Lipo NiMh Battery Balance Charger B6AC Lipo Charging XT60/T Plug Adaptor Board 2-6S 
ATTINY85 Development Board ATTINY85 USB Development Board ATTINY85 Module 
30A ESC 30A BLDC ESC Electronic Speed Controller with Connector 
DALY 4S 12V 100A BMS Board LifePo4 Battery Protection Board Battery Management System 
USB to Micro USB Cable USB A Type to Micro USB B Type 1M Cable (Colour May Vary) 
CX-10A 4 Channel Mini Quadcopter Mini Drone Headless Mode 2.4Ghz 4 Channels Radio Control 6 Axis RC Quadcopter Smallest RC Quadcopter Easy to Fly Mini Drone Indoor/Outdoor Quadcopter 
2Wd Transparent Smart Motor Robot Car Battery Box Chassis Kit For Arduino 
Pixhawk I2C Splitter Pixhawk I2C Port Expand Board with Cable 
DIY NANO IO Shield V1.O Expansion Board Compatible with Arduino 
Sky Blue PLA PRO+ 
Waveshare 2inch LCD Display Module for Raspberry Pi Pico, 65K Colors, 320×240, SPI 
ULN2003 Stepper Motor Driver ULN2003A Driver Module Stepper Motor Driver Board 
S500 Quadcopter Frame FPV Frame Multi Rotor Air PCB Frame With High Landing Gear For FPV Quad-Copter Frame With High Landing Gear - OG Carbon Fiber 
Bambu Lab X1E 3D Printer Combo 
DIY 4-Wheel Smart Car Chassis Kit 4WD Robot Car Chassis Platform Smart Car Chassis Kit Line Follower Robot Chassis Easy To Assemble 4-wheel Robot Car Kit 
Radiolink Byme-DB Flight Controller, 3 axis Gyro stabilizer RC Plane Gyroscope, 4 CH 3 Flight Modes FC, Applicable for Delta Wing, Paper Plane, J10, SU27, F22, for Beginner and Experienced 
MX1919 Motor Driver Module MX1919 Motor Drive Shield Board 2.5A Dual-Circuit Motor Drive Module for Arduino 
Nano Uno Expansion Board Nano Uno Multipurpose Expansion Board Multipurpose Expansion Module 
Nextion NX8048T050 5.0" HMI Touch Display 5-inch Basic Series Display Touchscreen Display for Arduino Raspberry Pi 
Bambu Lab TPU 95A HF 1.75mm 3D Filament Red 
1*40 Single Row Female Pin Header Connector Strip(2.54mm Pitch) 
FS-SM100 USB Simulator Cable with Adapter Cables for Flysky FS-i6 FS-i4 FS-TH9X FS-T6 FS-T4B FS-GT3 FS-GT2 Remote Controller 
L298N Based Dual Motor Driver Speed And Direction Control Raspberry Pi-Controlled Dual Motor Driver Motor Driver Circuit Build Your Own Robot 
10Values 200PCS NPN PNP Power Transistor Assortment Assorted Kit BC327-BC558 with Clear Plastic Box 
30mm Long 6mm Hex Wheel Coupling For Robot Smart Car Motor Shaft Adapter 
720mm NEMA17 Stepper Motor Cable Pure Copper 720mm Cable with Connector for NEMA17 Stepper Motor
Reviews
There are no reviews yet.