-53%

NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC

Original price was: ₹19.00.Current price is: ₹9.00.

Description
Reviews (0)

Description

Description:

The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.

Specifications:

Package/Case: DIP-8
Minimum Supply Voltage: 4.5V
Maximum Supply Voltage: 16V
Product Series: NE555
No. of Timers/Counters: 1
Operating Temperature Range: 0 ~ 70°C

Features:

Timing from microseconds through hours
NE555 Timer IC operates in both astable and monostable modes
NE555 Timer IC has adjustable duty cycle
Output can source or sink 200 mA
Output and supply TTL compatible
NE555 Timer IC has normally on and normally off output
NE555 Timer IC is available in 8-pin MSOP package

Pin Description:

Pin	Name	Purpose
1	GND	Ground reference voltage, low level (0 V)
2	TRIG	The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin.
3	OUT	This output is driven to approximately 1.7 V below +Vcc, or to GND.
4	RESET	A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold.
5	CTRL	Provides “control” access to the internal voltage divider (by default, 2/3 Vcc).
6	THR	The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open).
7	DIS	Open collector output which may discharge a capacitor between intervals. In phase with output.
8	VCC	Positive supply voltage, which is usually between 3 and 15 V depending on the variation.