Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
NEO-M8N GPS Module With Active Ceramic Antenna: Reliable and Accurate Location Data For Real-Time Tracking, Mapping, and Geolocation Projects 
T0-220 70pcs 14 Values Transistor Kit Three Terminal Voltage Regulator Transistor Kit 
X7 3DR Radio Telemetry Open Source 5KM 1000mW 1W 915MHz for APM Pixhawk Flight Controller - 915MHz 
Radiolink Byme-D Flight Controller Radiolink Byme-D Stabilizer 3 Channels Flight Controller with Gyroscope 3D Fly FC for Delta Wing Paper Plane 
1400KV BLDC Motor A2212 10T 1400KV Brushless Motor for Drone 
12*4.5 Propeller 1245 Carbon Fiber Nylon Propeller - CW&CCW - Black 
Concrete Grey PLA PRO+ 
XYQ-2 DIY Drone Mini Toy Drone Aircraft With Remote Wooden Assembly Mini Drone Quadcopter 
Radiolink R12DSM RC Receiver R12DSM 2.4Ghz 12 Channels Micro RC Receiver SBUS/PPM Long Range Control for FPV Racing Drone, Quadcopter, Helicopter 
Lime Green PLA PRO+ 
2200KV BLDC Motor A2212 6T 2200KV Brushless Motor for Drone 
APM 2.8 Flight Controller Flight Control Board Straight Pin For Quadcopter Multicopter Flight Controller 
Multi-function 4WD Robot Car Kit Ultrasonic Module UNO R3 Assembly Compatible with Arduino 
N20 Micro Gear Motor 12V 120 RPM Micro Metal Gear Motor With Encoder High-Torque Low-Speed Precision Micro Gear Motor 
5mm Yellow LED Light Emitting Diode (Pack of 5) 
N20 Motor with Wheel N20 Geared Motor Rubber Wheel Kit 12V 
Raspberry Pi 3B+ Starter Kit: Your All-in-One DIY Computer Pi 3B+ Starter Pack Ideal For Coding, Programming And More
Reviews
There are no reviews yet.