Description
Description:
The NE555 Timer IC is a highly stable device for generating accurate time delays or oscillation. Additional terminals are provided for triggering or resetting if desired. In the time delay mode of operation, the time is precisely controlled by one external resistor and capacitor. For astable operation as an oscillator, the free running frequency and duty cycle are accurately controlled with two external resistors and one capacitor. The NE555 Timer IC may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
Specifications:
- Package/Case: DIP-8
- Minimum Supply Voltage: 4.5V
- Maximum Supply Voltage: 16V
- Product Series: NE555
- No. of Timers/Counters: 1
- Operating Temperature Range: 0 ~ 70°C
Features:
- Timing from microseconds through hours
- NE555 Timer IC operates in both astable and monostable modes
- NE555 Timer IC has adjustable duty cycle
- Output can source or sink 200 mA
- Output and supply TTL compatible
- NE555 Timer IC has normally on and normally off output
- NE555 Timer IC is available in 8-pin MSOP package
Pin Description:
| Pin | Name | Purpose |
| 1 | GND | Ground reference voltage, low level (0 V) |
| 2 | TRIG | The OUT pin goes high and a timing interval starts when this input falls below 1/2 of CTRL voltage (which is typically 1/3 Vcc, CTRL being 2/3 Vcc by default if CTRL is left open). In other words, OUT is high as long as the trigger low. The output of the timer totally depends upon the amplitude of the external trigger voltage applied to this pin. |
| 3 | OUT | This output is driven to approximately 1.7 V below +Vcc, or to GND. |
| 4 | RESET | A timing interval may be reset by driving this input to GND, but the timing does not begin again until RESET rises above approximately 0.7 volts. Overrides TRIG which overrides threshold. |
| 5 | CTRL | Provides “control” access to the internal voltage divider (by default, 2/3 Vcc). |
| 6 | THR | The timing (OUT high) interval ends when the voltage at threshold is greater than that at CTRL (2/3 Vcc if CTRL is open). |
| 7 | DIS | Open collector output which may discharge a capacitor between intervals. In phase with output. |
| 8 | VCC | Positive supply voltage, which is usually between 3 and 15 V depending on the variation. |
Package Included:
1 x NE555 Timer IC 555 DIP-8 General Purpose Single Bipolar Timer IC
KK2.1 Flight Controller KK2.1 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 
Radiolink Mini PIX Flight Controller Mini Pixhawk Controller Mini Pix APM Flight Controller V1.2 FC for 3-6 Axis FPV Drone/Helicopter/Aircraft/Quad/Car/Boat 
A2217 2300KV Brushless Motor with Banana Connector Brushless Out-Runner Motor With Welded Banana Connector Boost Your Quadcopter With Brushless Motor High Efficiency Motor For RC Models 
DYS D2822 Brushless Motor D2822 1450KV Outrunner Brushless Drone Motor (Original) 
DALY 4S 12V 100A BMS Board LifePo4 Battery Protection Board Battery Management System 
4-Pin 10mm LED Connector 4-Pin 10mm Waterproof LED Connector 10mm Male/Female LED Connector For RGB / RGBW / RGBWW Colour 5050 LED Strips, Pack Of 2 
Waveshare 1.3inch LCD Display Module For Raspberry Pi Pico Display 240×240, 65K Colors,RGB Colors LCD IPS Screen,SPI Interface 
Crystal Clear PLA PRO+ 
Midnight Black PLA PRO+ 
N20 Micro Motor 6V 300 RPM Micro Motor Micro Metal Gear Motor High-Torque Micro Motor Low-Noise Micro Motor High-Efficiency Micro Motor For RC Models 
3-6S 380KV 4108 Multi Rotor Brushless Motor Helicopter Drone Disc Brushless Motor 380KV RC Helicopter High-Performance Multi-Rotor Motor for RC Drone FPV 
158mm/6mm GT2 Timing Belt GT2 Closed-Loop Belt Durable Rubber GT2 Pulley Belt High-Quality GT2 Timing Belt For Precision Applications 
Nextion NX8048T050 5.0" HMI Touch Display 5-inch Basic Series Display Touchscreen Display for Arduino Raspberry Pi 
100k ohm Rotatry Potentiometer 3 Terminals Rotary Shaft Potentiometer Variable Resistor Linear Taper Rotary Potentiometer Pots 
X7 3DR Radio Telemetry Open Source 5KM 1000mW 1W 915MHz for APM Pixhawk Flight Controller - 915MHz 
Radiolink R6FG RC Receiver R6FG 6 Channels 2.4GHz RC Receiver with Gyro, Surface Long Range Control RX for Vehicle Drifting/Crawler/Truck/Boat Works with Radio Controller RC4GS V3/RC6GS V3/RC4GS V2/RC6GS V2/T8FB/T8S 
15-22 Inch Propeller Adapter Quick Release Prop Adapter CW&CCW For 15-22 Inch Prop / M3 15mm Hole Motor (Without Mounting Plate) 
Raspberry Pi High Quality Camera RPi Cam High Quality High-Resolution Premium Camera Module C/CS Mount Or M12 Mount For Your Pi Projects
Reviews
There are no reviews yet.